Ecojet BOB Portable Tabletop Misting Fan

The manufacturer guarantees Joape Angra against any manufacturing defects within
the period of twelve months, from the date on the sales invoice.
Warranty Condition:
Any defects must be immediately communicated to a U.S. Joape distributor, along
with the original bill of sale or sales receipt.
Warranty will be deemed null and void when:
1 - The serial number or the label with the product identification number has been
removed or altered.
2 - The product was installed or used in nonconformity with the instructions in this
user's guide.
3 - If the product was altered, changed or repaired by a anyone who is not
accredited by Joape Ind. Equipamentos Ambientais.
4 - Defects caused by accidents or consumer's misuse of the product.
The warranty does not cover:
Expenses related to the consumer travel to obtain technical assistance.
Expenses related to the installation of the product.
Expenses related with the cleaning of the equipment.
Scratches, marks, dents or damage to the products or parts due to transportation or
handling accidents.
Power failures or surges resulting from electrical power supply problems.
Acts of nature
Remarks:
Joape Ind. Equip. Ambientais, in the attempt to continuously improve its products,
has the right to change general, technical and aesthetic characteristics of products
without prior warning.
This warranty certificate is valid for all products sold by Joape's certified distributors
and used in the US territory.
Keep the User's manual, and the Invoice handy, for future reference and warranty
service requests, whenever necessary.

In areas with hard water, it may be necessary to
occasionally clean the pump. Also in areas with
hardwater, at the end of the season or if not used for long
periods, follow this recommended cleaning procedure:
1 - Disconnect the equipment from the electrical outlet
2 - Use liquid detergent and a brush to clean the
equipment.
3 - When the equipment is not used for more than 7 days,
the reservoir must be emptied, and cleaned, then run all
water through once.
4 - In areas with hard water, it may be necessary to
occasionally clean the submersible water pump inside the
reservoir.
Cleaning the Water Pimp
Remove the pump from the water reservoir (picture 4).
2 - Remove the frontal cover of the water inlet (picture 5/item "A").
3 - Remove the protective cover from the rotor (picture 5/item "B").
4 - Remove the propeller from the engine (picture 5/item "C").
5 - Clean all pump parts with water and neutral liquid soap.
6 - Rinse all parts and reassemble the pump.